Specifications

Installation Instructions
13.0 Using the C-Touch Colour Transfer Utility
The C-Touch Colour Transfer Utility is used to transfer a software project to
the C-Touch Colour. It is included with the PICED software, which is
available from the Downloads section of the CIS web site
(http://www.clipsal.com/cis).
This section takes you through the process of installing a project onto the
C-Touch Colour, using a direct Ethernet connection. It is also possible to
install projects to multiple C-Touch Colour units via a common DHCP
network, or a network where each C-Touch Colour has been configured
with an appropriate static IP Address.
1) Once the C-Touch Colour has been installed and switched on, you
should see the default screen in Figure 17. You must configure the
unit with an IP address and customised project file, before it is ready
for use.
Figure 17 – The initial screen of an unconfigured C-Touch Colour Touch Screen
27