Specifications

C-Touch Colour Touch Screen
Figure 6 - Installing the plasterboard bracket
To install the plasterboard bracket:
1) Prepare a 208 × 162 mm cut-out in the plasterboard.
2) Place four 4 mm holes in the plaster board to provide clearance
for the screws that secure the Colour Touch Screen.
3) Using the four short screws supplied, attach the side clamps to the
bracket as illustrated.
4) Ensure the four screws securing the side clamps are loose, and the
side clamps can move freely.
5) Rotate the bracket 90 degrees to the cut-out and feed it into the
wall cavity.
6) Once the entire bracket is inside the cavity, rotate it 90 degrees to
match the cut-out.
7) Position the bracket so the side clamps feed through the cut-out,
clamping onto the edge of the plasterboard.
8) Tighten the side clamp screws.
9) Insert the Colour Touch Screen.
10) Fasten the Colour Touch Screen to the bracket using the four long
screws supplied.
12