User`s guide

3 of 40
© Clipsal Australia Pty Ltd
5000CTC2 Series C-Touch Colour Touchscreen Installation Instructions
1.0 Product Range
2.0 Important Notes
• The 5000CTC2 series touchscreens must only be used with the 5000CTCPS/2
power supply. Power supply must be purchased separately.
• Do not connect mains directly to the touchscreen.
• Be sure to connect the pink C-Bus cable to one of the two C-Bus RJ45
connectors on the left side of the touchscreen (viewed from the front). Do not
attach the C-Bus cable to the touchscreen’s Ethernet RJ45
connector, as this
may damage the unit and void the warranty.
• Using any non-C-Bus software with C-Bus hardware without the written consent
of Clipsal or Schneider Electric may void the hardware warranty.
• Changes or modifications not expressly approved by Clipsal or Schneider
Electric could void the user’s authority to operate the equipment.
• To comply with EMC regulations the included ferrite filters must be fitted to any
audio, or IR cables connected to the touchscreen. Refer to Sections 7.3 and 7.4.
• Cabling for this product should be performed by a suitably qualified person, in
accordance with the laws and requirements of the state or country of installation.
• Do not overtighten the screws when securing the touchscreen to the wall. Doing
so may distort the casing, making attachment of the fascia more difficult.
Table 1. C-Touch Colour Touchscreen product range
Several colour options are available. Contact you local sales representative for
more information.
Catalogue Number Description
5080CTC2-xx 6.4-inch Colour Touchscreen, wall mount,
Saturn surround
5050CTC2-xx 6.4-inch Colour Touchscreen, wall mount,
Neo surround
BS5000CTC2 6.4-inch Colour Touchscreen, wall mount,
brushed stainless steel surround
5000CTCPS/2 Power supply (non-UK, for 50xxCTC2 models only)
5000CTCPS/2B Power supply (UK, for 50xxCTC2 models only)
5035TX2 Infrared remote control