User`s guide

29 of 40
© Clipsal Australia Pty Ltd
5000CTC2 Series C-Touch Colour Touchscreen Installation Instructions
16) Click the Control tab to select the Control page shown in Figure 23.
From the control screen, you can start and stop the touchscreen’s project
(in HomeGate), enable logging, set the time and change the name that
identifies the touchscreen over an Ethernet connection.
Figure 23. The Control page in the Transfer Utility software
17) Ensure that the time on your PC is set correctly. If not, change the current
setting by double clicking the clock on the lower right of the screen (if present).
18) Click the Set Time button in the Transfer Utility software. This will set the time on
the touchscreen to the same time as your PC. No feedback is given to
indicate that the time on the touchscreen was changed.
19) You can change the name that will identify the touchscreen when controlled
over an Ethernet connection. Click the Rename C-Touch Colour button.
Click Yes when asked to confirm the change of name. Renaming the unit is
especially useful if multiple touchscreens are to be connected to the same
Ethernet network.
Figure 24. Confirming a name change
NOTE
Using the C-Touch Colour on a network follows the same principles as
direct connection. You might need assistance from a network administrator.