User`s guide

25 of 40
© Clipsal Australia Pty Ltd
5000CTC2 Series C-Touch Colour Touchscreen Installation Instructions
2) Remove the fascia if it has been fitted to the unit.
3) Plug the supplied programming lead (red crossover cable) into the RJ45 socket
on the front right side of the touchscreen.
4) Ensure that your PC is switched on and plug the other end of the crossover
cable into the Ethernet socket on your PC.
5) Wait approximately three minutes to enable the network’s DHCP connection to
establish. You can skip this step if your PC has a static IP address.
6) Start the C-Touch Colour Transfer Utility by clicking the C-Touch Colour Transfer
Utility in the PICED folder in the Windows Start menu, or select Connect to Unit
in PICED’s Transfer menu.
7) If your PC has multiple network adapters (which are enabled), you will see a list
of available network devices. If the screen is not displayed click Select Network
Adapters from the Search menu. Select the network adapter where the patch
cable is connected and click OK.
Figure 16. Select the network card used to connect to the C-Touch Colour
8) The software searches for C-Touch Colour Touchscreens. If your PC uses a
static IP address, it is likely that no touchscreen will be found in the case of
newly installed units. If the touchscreen is not detected, go to Step 13.