User`s guide

10 of 40

5000CTC2 Series C-Touch Colour Touchscreen Installation Instructions

Figure 5. Installing the plasterboard bracket.

To install the plasterboard bracket:

1) Prepare a 208 × 162mm cut-out in the plasterboard.

2) Place four 4mm holes in the plaster board to provide clearance for the screws

that secure the touchscreen.

3) Using the four short screws supplied, attach the side clamps to the bracket

as illustrated.

4) Ensure the four screws securing the side clamps are loose, and the side

clamps can move freely.

5) Rotate the bracket 90 degrees to the cut-out and feed it into the wall cavity.

6) Once the entire bracket is inside the cavity, rotate it 90 degrees to match the

cut-out.

7) Position the bracket so the side clamps feed through the cut-out, clamping onto

the edge of the plasterboard.

8) Tighten the side clamp screws.

9) Insert the Colour Touchscreen.

10) Fasten the Colour Touchscreen to the bracket using the four long

screws supplied.