ClippperCreek HCS Series Manual

HCS User Manual

HCS EVSE Mounting for Hollow-Wall Construction

• Place the unit such that both mounting holes can take

advantage of solid structural framing inside of the wall or a

strong wall surface such as plywood.

• Size ¼”- 20 lag screws are recommended for mounting the

HCS to a wooden structure. Pre-drill appropriately sized pilot

holes to allow the lag screw to grip the wooden structure while

preventing the wood from cracking or splintering while the

screw is fastened.

• The included plastic angle washers can be oriented to allow

the lag screws to be fastened at an angle while still providing a

solid at backing to the screw head.

• If the screw head is smaller than the ⅜” (1 cm) washer

aperture, an additional at washer will need to be placed

between the plastic angle washer and the head of the lag screw.

• If either mounting hole does not have a solid mounting

structure (such as drywall without a solid backing) it will be

necessary to use proper anchoring hardware such as drywall

toggles or molly bolts.

Figure 5: Mounting the HCS to a Hollow-Wall

17"