Owner`s manual

• For Additional Safety Use A Ground Fault-Interrupter (GFCI ) Device.

• Do Not Use The Drill In Inflammable, Gaseous, Or Explosive Atmosphere

• Do Not Expose The Drill Motor To Rain Or Use In Damp Or Wet Locations

• Do Not Abuse The Cord, Or Carry Or Lift The Motor By The Cord

• Keep The Power Supply Cord Away From Humidity And Water

• Make Sure That The ON/OFF Switch Is In The “OFF” Position Before Plugging

Into A Power Supply

• Unplug The Drill Before Changing A Drill Bit

• Unplug The Power Cord When Attaching The Water Supply, Also Turn The

Water Valve To The “Off” Position Before Attaching

• Do Not Use If Parts Of The Motor Housing Are Missing Or Damaged

• Do Not Use If The Power Cable Or Extension Cable Is Damaged

• Do Not Make Any Attachments, Adjustments, Or Accessory Changes With The

Unit Plugged In

• Always Use The Proper Length/AWG For Extension Cords (See The Section

Titled Electrical Supply)

♦ If Water Comes Out Of The Over Flow Bore (Item 3) Stop The Drill Operation

And Replace The Water Ring Seal Immediately

♦ DO NOT Use Or Reuse Waste Water. Dirt And Slurry May Damage The Ring

Seals

• Prevent Water From Spraying On Any Part Of The Electrical Motor Or Cables

II. OPERATION

A. Core Bit Installation

Adapters are needed to install specific sized core bits.

1. Using a wrench to firmly hold the output shaft, screw the core bit onto the

spindle until snug.