Owner`s manual

16
6.3 Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially
water pan, motor and blade flange. To clean disconnect the machine from the power
source and wipe down the CTC701 with a damp cloth.
7. Trouble Shooting
7.1 Trouble Shooting Procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the
electrical supply. Any works dealing with the electrical system or supply of the machine
can only be carried out by a qualified electrician.
7.2 Trouble-Shooting Guide
Trouble Possible Source Resolution
Motor Is Not Running No Electricity Check The Electrical Supply
(Circuit Breaker For Example)
Extension Cable Is Too Small
Of Gauge Or Too Long
Change Extension Cable
Do Not Exceed A 50’ 10AWG
Defective Extension Cable Change Extension Cable
Defective Switch CAUTION : Can Only Be
Solved By Qualified Electrician
Defective Motor Change Motor Or Contact
Motor Manufacturer
No Water On The Blade Not Enough Water In The Pan Refill The Water Pan
Cuts Are Not Straight Guide-A-Cut Is Not Properly
Adjusted
Check And Realign The Guide-
A-Cut
Blade Is Not Cutting The
Material
Incorrect Blade Specification
For Material Being Cut
Replace Blade With The
Correct Norton Diamond Blade
Specification.
Material Is Chipping Too Fast Of Cut Speed
Incorrect Blade Specification
Slow Feed Speed Of Tile
Replace Blade With One Of
The Correct Specification