Specifications

20
2. Remove the operators Right hand side blade nut (NOTE: Left hand
thread) and Loose Collar.
2. Remove the blade from the saw if installed.
3. Remove the Blade Guard buy loosing the Blade Guard Locking Screw
located on the front side of the Blade Guard and remove the Blade Pivot
Bolt, Washer, and Nut from the rear of the Blade Guard.
4. Remove the Blade Shaft Guard from the operators left hand side of the
machine.
5. Swap the sides of the Blade Guard Locking Screw (now should be on the
Right side of the guard).
6. Reroute the Water Hose around to the Left side of the machine. NOTE:
Do not let the Water Hose come in contact with the Muffler or the Engine.
7. Attach the Blade Guard to the operator’s Left hand side of the machine.
NOTE: The head of the Blade Pivot Bolt goes to the inside of the frame.
The Nut goes to the outside of the blade guard. Tight down the Blade
Guard Locking Screw.
8. Remove the Operator’s Left hand side Blade Nut and Loose Collar.
9. Place the Blade on the Operator’s Left hand side of the Blade Shaft.
10. Attach the Loose Collar and Operators Left hand side Blade Shaft Nut to
the machine. Properly tighten the Blade Shaft Nut.
11. Attach the Operator’s Right hand side Loose Collar and Blade Shaft Nut.
12. Attach the Blade Shaft Guard to the Operator’s Right hand side of the
machine.
13. Remove the Pointer and reattach it to the Operators Left hand side of the
machine. NOTE: Reverse the orientation of the Pointer.
14. Retighten all Screws.
15. Reattach the Spark Plug Wire.