Owner`s manual

Additional Guide Lines For Sawing:

 Understand and follow all of the instructions in this owner’s manual.

 If wet cutting, turn on the water supply so that there is a minimum of 4-6

gallons per minute of water flow!!

 In critically hard aggregate, more than a single pass may be needed to cut

the desired depth.

 If the saw stalls in the cut, immediately stop the forward speed and raise

the blade out of the cut. If this is not done the belts can fail or the blade

may be damaged.

 Go slowly with a new blade until it opens up, that is, until the diamonds

can be seen and felt.

I. Lead-Off Adjustment

If the saw tends to pull to one side (lead off), it may be steered by applying

slight pressure to the left or right hand handles.