Owner`s manual

17
F. Controls
Raise
Levantar
RPM/Hours (RPM/Horas)
Lower
Bajar
3600 RPM
Ignition
Ignicion
Emergency
Stop
Paro de
Emergencia
Blade Dia
Eng rpm
Eng Pulley
Diameter
Blade Shaft
RPM
Blade Shaft
Pulley Dia
Diametro de
Disco
Motor rpm
Diámetro en
Polea Motor
Flecha Disco
RPM
Diámetro en
Polea de
Flecha Disco
16" (406mm)
3,600 rpm
3.15" (80mm)
2,520 rpm
4.5" (114mm)
16" (406mm)
3,600 rpm
3.15" (80mm)
2,520 rpm
4.5" (114mm)
20" (508mm)
3,600 rpm
3.15" (80mm)
2,520 rpm
4.5" (114mm)
Blade Speed Chart
Tabla de Velocidad
Del Disco
Throttle
Acelerador
Depth Control Hand Wheel:
Controls the cutting depth of the blade. Rotate Clockwise to raise and
counter clockwise to lower the depth of cut.
Engine Throttle:
The Engine Throttle Control allows the operator to adjust the Engine
Speed while starting and operating the machine. To increase the Engine
Speed push the Engine Throttle Control forward. To decrease the Engine
Speed pull the Engine Throttle Control to the rear.
Engine Ignition Switch:
The Engine Ignition Switch allows the operator to start and stop the
engine. The C1320P is equipped with a manual start engine. The engine
will not start unless the Ignition Key is in the On position, Emergency Kill
Switch is pulled out, and the Engine Starter Rope is pulled.
Tachometer/Hour Meter
Emergency Kill
Switch
Engine
Throttle
Engine Ignition
Switch
Depth Control
Hand Wheel