Owner`s manual

7. Tighten the blade shaft nut (counter-clockwise for the Operator’s Right

Hand side and clockwise for the Operator’s Left hand side).

8. Insure that the Blade Guard is lowered and the Blade Guard Locking

pin is secure. Close Blade Guard Nose. See Blade Installed

diagram below.

Blade Installed

9. Reconnect the spark plug.

Observe rotation arrow on blade and do not exceed maximum

RPM stamped on blade.

NOTE: Organic bonded blades (A) must have a blotter. The

blotter (B) must extend past the blade collar contact area as

shown.

Blades Use Only Norton Diamond Blades