Specifications

Transmission Engage/Disengage Lever:

Controls the Engagement and Disengagement of the Transmission. Push

down to Engage and pull up to disengage the transmission. Only operate

the Transmission Engage/Disengage Lever when the machine is NOT

moving. Operation of the Transmission Engage/Disengage Lever while

the machine is moving may damage the Rear Wheels. When the

Transmission Engage/Disengage Lever is in the Disengage position the

machine can be moved with out the engine running. NOTE: When

parking the saw, it should always be left in the Engaged position, Speed

Control Lever in the neutral position, the engine OFF, and perpendicular

(right angle) to the grade (hill).

Speed Control Lever:

Controls the forward and reverse speed of the Transmission. To increase

the forward speed push the lever forward with the engine running at full

speed and the Transmission engaged. To reverse move the Speed

Control Lever towards the rear of the machine. NOTE: The further

forward or reverse the Speed Control Lever is moved the faster the

machine will move in this direction. To place in a neutral speed condition

place the Speed Control Lever in the center. NOTE: Over time the

neutral position may change slightly due to cable stretch and mechanical

component wear. Either re-adjust the Transmission Control Cable

Linkage or move the Transmission Speed Control Lever to it’s new

position.

Choke 20 HP ONLY:

Units with a 20 HP Engine (C2016SS, C2020SS, and C2024SS) are

equipped with a remote mounted Engine Choke Control. To operate the

Choke pull the control lever out away from the machine and then follow

the instructions for starting the engine found in the Engine manual. All 13

HP units are equipped with a Choke control attached to the Engine below

the Air Cleaner on the Operator’s Right Hand Side.

Engine Throttle:

The Engine Throttle Control allows the operator to adjust the Engine

Speed while starting and operating the machine. To increase the Engine

Speed push the Engine Throttle Control forward. To decrease the Engine

Speed pull the Engine Throttle Control to the rear.