WIDTH Adjustable from 71 to 80,5 cm HEIGHT Top of gate to floor 78 cm Pressure Fit Gate (Metal) A x4 B x3 C x2 D x4 E x1
WARNING - INCORRECT FITTING OR POSITIONING OF THIS SAFETY BARRIER CAN BE DANGEROUS Fixing surfaces must be suitable for the purpose and structurally sound. This product requires the purchase for the surface to which the wall a round shaped newel post, ‘Y’ shaped spindles are available separately which replace the screw adjusters and wall cups supplied with this gate.
Installation 1 On the latch side of the gate, insert 1 screw adjuster ‘A’ with nut ‘B’ into the holes provided on the bottom of the gate. Screw 1 screw adjuster ‘A’ into the hole provided next to the handle. On the other side of the gate insert 2 casings ‘C’ followed by 2 screw adjusters ‘A’ with nuts ‘B’ into the holes provided. Be sure to insert both casings ‘C’ with the notch facing downwards.
3 Place the gate in the desired opening and push the latch downwards gently. The screw adjusters will extend and the latch should ‘click’ into place indicating that the gate is secure. If you feel a lot of resistance STOP and screw the screw adjusters further into the frame. Check the pressure indicators on the top and bottom corners of the frame. When the gate is under no pressure, the red plastic indicator should be completely visible.
E Using the Gate 2 1 Ensure the gate is in the open position by pressing the button (1) and then lifting the latch (2), this will retract the screw adjuster on the gate. To open the gate, lift it slightly. To close the gate, lift it slightly so that the bottom sits back on the frame and push the handle down firmly. Always check that the gate is closed and locked before leaving unattended.
Fitting a 7cm Extension G Remove the screw adjusters ‘A’, nuts ‘B’ and the casings ‘C’ from the hinge side of the gate (1). Turn the screw adjuster casings ‘C’ upside down and re-insert them into the frame (2). They should extend slightly from the frame. Attach the extension ‘F’ onto the casings (3). Fasten the screw adjusters ‘A’ and nuts ‘B’ into the extension ‘F’ (4).
I Fitting a 7cm & a 14cm Extension Together 1 Remove the screw adjusters ‘A’, nuts ‘B’ and the casings ‘C’ from the hinge side of the gate (1). Insert the long end of the extension ‘I’ directly into the frame making sure that the notches are facing downwards (2). Place the tops ‘J’ onto both ends of the slat ‘K’ (3). Place this on the short end of the extension ‘I’ (4).
5 7 6 H F H J Check the gate periodically to ensure that the wall surface, wall cups, spindles and locking devices are all functioning correctly. Additional and replacement parts can be obtained by contacting the Clippasafe Customer Services Department via the Careline or e-mail address below. Clean the gate using warm water and a mild detergent. No part of the gate requires lubrication. Never use solvents, chemicals, scouring powders or sharp tools to clean the gate. Model No.
