User manual

26
7.3.1. Set Ringer
① Select “1: Set Ringer”, then, ringer configuration sub-menu appears as follows:
1: Ringer Melody
2: Ringer Volume
② Select “1:Ringer Melody” : use VOL (▲,▼) buttons to locate an appropriate ringer melody and
press ENTER button to change current ringer melody setting.
③ Select “2:Ringer Volume” : adjust volume using VOL (▲,▼) buttons and press ENTER button to
change current ringer volume setting.
7.3.2. Screen Msg
① To change screen message, select “2:Screen Msg” and then, a sub-menu appears as follows:
1: User Defined
2: Use ID
② Default screen message of CP-100/100D is “CLIPCOMM CP-100/100D,” which can be changed.
To change screen message of your CP-100/100D, select “1:User Defined” (your own message) or
“2: Use ID.” (in H.323 version, H.323 ID or E.164 ID)
③ Press ENTER button and then the initial screen message will be changed.
7.3.3. Time Server
① Your CP-100/100D communicates with a time-server to get information on current time. To change
the time-server, select “3:Time Server.”
Enter IP Address
211.234.222.98_
② Enter the IP address of new time-server using keypad. To confirm or cancel your input, press
ENTER or END button.
7.3.4. Time Zone
① Using this menu, you can set proper time zone of your location. The CP-100/100D displays
current wall-clock time according to the time information from a time-server interpreted by this
time zone. To set current time-zone of your CP-100/100D, select “4:Time Zone.”
Keison Products www.keison.co.uk [e-mail] Tel: [phone]