User manual

21
z Voice codec: The type of codec for voice compression and packetization.
z Sending DTMF: CP-100/100D can send DTMF with RTP packet(RFC2833) or INFO message.
z Max-Forwards: Valid number hops for SIP packets
z NAT Traversal: You can select “STUN” if you use NAT traversal function with STUN server.
Otherwise you can select “Manual” if you use NAT traversal function without STUN server.
z STUN Server(FQDN): If you use NAT traversal with STUN server, input the address of STUN
server. This address can be FQDN.
z NAT Router IP: If you use NAT traversal without STUN server, input the address of your NAT
router.
z NAT Timer: you can set time to send packets for keeping NAT session
5.7. Wireless LAN Configuration
Before using the wireless LAN functions of your CP-100/100D, make sure that an interoperable
wireless LAN PC card is used. An interoperable 802.11b PC card is based on Intersil’s Prism chipset
and original Intersil firmware. Examples of interoperable wireless LAN cards include Linksys’s WPC11,
SMC’s 2632W, and Gemtek’s WL-211.
Item Meaning
Default
Value
Mode
Disable : Don’t use wireless LAN.
AP : Wireless LAN interface operates as a wireless LAN access point.
Station : Wireless LAN interface operates as a wireless LAN station
Disable
ESSID
Set ESSID. If the ‘Mode’ above is ‘AP’, this should be a unique ESSID of the
wireless service area, and if the ‘Mode’ is ‘Station’, this should be the same
as the ESSID of the Wireless LAN AP to which CP-100D will connect.
clip
Channel Frequency band to use for communication with AP 1
Rates Data-rate to use for communication with AP All rates
WEP
Mode : Encryption mode for secure 802.11b communication.
(Disabled / 64 bit / 128 bit )
Key # : seed string used for encryption
Default Key : key index to be used for encryption
Disabled
WLAN
DHCP
server
In the ‘AP’ mode,
Disable : Turn off the CP-100D’s DHCP server
Enable : Turn on the CP-100D’s DHCP server for wireless LAN clients.
Enable
Keison Products www.keison.co.uk [e-mail] Tel: [phone]