Assembly

1
2
3
Attach backrest to the table by lining up holes
in hinge with the 4 protruding bolts in the
center table brace. Secure the backrest with the
(4) four Kep
®
Lock Nuts and a 7/16" socket wrench.
Extend the pneumatic cylinder about half way by
holding the apparatus with one hand and pressing
down on one of the levers with the other.
Secure the pneumatic cylinder’s bracket to
the backrest with the (8) eight 3/4" pan head
screws.
4
Locate the seat brackets and place padded seat
on top of the brackets.
Secure the seat to the seat brackets using (4)
four 1" hex head bolts and 3/4" washers.
DO NOT TIGHTEN ALL THE WAY.
Check the alignment of the seat in relationship
to the backrest, slide the seat side to side to
adjust if necessary.
When satisfied with the alignment, tighten the bolts from
step 5 all the way, making sure the seat is in a fixed and
secure position.
5
6
BRACKETS