User's Manual

3
Locating a suitable position for the
Control Panel
 The Control Panel requires main power and
a constant cellular network reception.
 The Control Panel should be easily
accessible.
 The Control Panel should not be placed in
a damp location, such as a bathroom.
 The Control Panel should not be placed
close to any heat source, such as
microwave ovens, which can reduce signal
strength.
 The Control Panel should not be located
alongside other radio transmitting devices,
such as mobile phones, cordless phone, or
wireless computer network (Wi-Fi) devices.
 Important: When drilling into a wall, ensure
there are no hidden cables or pipes.
Mounting the Control Panel
The Control Panel can be mounted on the wall
or wherever desired (e.g. on the table). Ensure
the Control Panel is fitted at approximately at
chest height where the buttons, microphone,
and speaker can be easily accessed and
operated.
 Use the 2 holes of the Wall Mounting
Bracket as a template, mark off the holes’
positions.
 Drill 2 holes and insert the wall plugs if
fixing into plaster or brick.
 Screw the base to the wall.
 Hook the Control unit onto the Wall
Mounting Bracket (holding the unit with the
front facing you).
1.5. Programming cable and
Local Firmware Update
cable
 CTC-1052-QT-DT35A has a QT cable A for
PC programming and a QT cable B for
Local firmware update (optional items,
sold separately).
 To perform PC programming, the QT cable
A must be plugged into the Programming
Telephone Jack of CTC-1052-QT-DT35A,
and then connected to PC.
 To perform Local firmware update, the QT
cable B must be plugged into the
Programming Telephone Jack of CTC-
1052-QT-DT35A, and then connected to
PC.
1.6. Compatible with Climax’s
SMS Editor
CTC-1052-QT-DT35A is compatible with
Climax’s SMS Editor, which is designed to
facilitate SMS remote programming via a PC.
This tool allows you to program the panel easily
from your computer, without sending complex
SMS text messages from a mobile phone.
QT cable A
QT cable B