User's Manual

2
— When pressing the button to power on
the panel, the panel will emit two
beeps.
— Around 30 seconds after powered on,
the cellular module will be activated,
the panel will play voice prompt
“Searching for Cell Signal”.
When GSM registration is
scuccessful, the panel will play voice
prompt “System Ready”.
11. DC Jack
— DC 12V 1A switching power
connection
12. Programming Telephone Jack
— The programming cable (QT cable A)
needs to be plugged into this jack
and connected to a PC for PC
Programming.
— The Local firmware update cable (QT
cable B) needs to be plugged into this
jack and connected to a PC for
Firmware Update.
(Refer to 1.5. Programming cable
and Local Firmware Update cable
for details.)
13. SIM Card Slot
14. Learn Button
— Press & hold for 6 secs: enter
Learning Mode.
— Press & hold for 6 secs in learning
mode: remove Pendant #1 and #2.
— Press & hold for 1 sec: 4G/LTE
automatically resets
— Press & hold for 15 secs to suspend
mobility timer
1.2. The Power Supply
 An AC power adapter is required to connect
to a wall outlet. Be sure only to use an
adapter with the appropriate AC voltage
rating to prevent component damage. A DC
12V output and 1.5A switching power
adapter is generally used to power CTC-
1052-QT-DT35A.
 In addition to the adapter, there is a
rechargeable battery inside CTC-1052-QT-
DT35A, which serves as a back-up in case
of a power failure.
 During normal operation, the AC power
adapter is used to supply power to CTC-
1052-QT-DT35A and at the same time
recharge the battery. It takes approximately
72 hours to fully charge the battery.
 After power is supplied to CTC-1052-QT-
DT35A, press the power button once to
power on the Control Panel.
1.3. Insert SIM Card
CTC-1052-QT-DT35A Panel features built-in
Cellular network communication facility to report
to the Monitoring Station.
 To Insert SIM card:
<NOTE>
 It is recommended to disable the SIM
card PIN code before inserting into the
Control Panel.
The SIM card base is located on the rear side of
the unit:
 Insert the SIM card with the chip side facing
up.
 Push to the furthest extend, then press on
the edge of the SIM card firmly to secure it.
 SIM Card will delete its SMS messages
whenever the CTC-1052-QT-DT35A is
powered on.
 To remove SIM card:
Press and release on the edge of SIM card, the
card will spring out.
1.4. How to install the Control
Panel