User's Manual

10
Emergency Button Enable
 The Help Button can be enabled or
disabled to send an Emergency alarm
report:
Function Selection Result
(0)
OFF
(Disable)
(1)
ON
(Enable)
 Factory Default is set as (1), ON.
 OFF: Pressing the Help Button is unable
to send an emergency alarm.
 ON: Pressing the Help Button will activate
the panel send an emergency alarm.
Command 35
Silent Mode
 CTC-1052-QT-DT35A can be selected to
operate in Silent Mode. This will mute all
normal operation warning beeps, guard
time tone and key tone.
<NOTE>
 Speech Reporting made under Silent
Mode will automatically be switched to
Listen-in, but call recipient can press
DTMF keys to open two-way
communication or change modes.
 If Command #31 is set as Enable,
CTC-1052-QT-DT35A will emit ring
tone for incoming calls even in silent
mode.
 Silent mode will not mute the long beep
emitted during walk test.
Function
Selection
Result
(0) ON (Silent)
(1) OFF (Normal)
 Factory Default is set as (1), OFF.
Command 37
AC Fault Report
 The CTC-1052-QT-DT35A can be
programmed to send a Fault Report when
an AC power failure is detected.
Function Selection Result
(0)
OFF
(Send No Report)
(1)
ON
(Send Report)
 Factory Default is set as (1), ON.
<NOTE>
 Reporting will only be made after
detecting AC Fault condition
continuously for one hour.
Command 38
Follow-On & Call-Back Function
Function Selection Result
(0)
Follow-On
(Reserved)
(1) Call-Back
(2) Follow-On & Call-Back
 When this function is programmed as (1),
after a successful reporting to the
Monitoring Center, CTC-1052-QT-DT35A
will automatically hang up the line and start
a 5-minute waiting period to auto answer
any incoming phone calls from the
Monitoring Center.
 When this function is programmed as (2),
after a successful reporting to the
Monitoring Center, CTC-1052-QT-DT35A
will automatically enter the Follow-On
mode.
Once Follow-On Mode is terminated, CTC-
1052-QT-DT35A will automatically start a 5-
minute waiting period to auto answer any
incoming phone calls from the Monitoring
Center.
 When the Monitoring Center calls back
within the 5-minute period (when call back