User's Manual

3
<
<
N
N
O
O
T
T
E
E
>
>
 Re-learning is only required if the WTRVS is removed, but not required after battery
replacement. To remove WTRVS, you have to remove it from the Control Panel first
and then reset it to factory default.
III. Battery
 The Wrist Transmitter uses one CR2 3V lithium battery as its power source. Please note:
ALWAYS replace battery with the correct size and voltage.
Press the Low Battery Detection Button to test the battery voltage. If the battery voltage is
low, WTRVS will respond for 3 short beeps. If the battery voltage is normal, WTRVS will
not emit beeps.
<
<
N
N
O
O
T
T
E
E
>
>
 It is prohibited to learn-in the WTRVS to the Control Panel when the WTRVS is in low
battery status.
 You are not allowed to test the battery status during the two-way communication mode
or the period of triggering emergency alarm.
To replace the battery:
1. Unscrew the battery cover.
2. Remove the old battery and press the Low Battery Detection Button once.
3. Put a new battery into the battery compartment.
4. Screw the battery cover back.
IV. Factory Default
To return WTRVS to factory default, you have to press and hold the Active/Pendant Button on
WTRVS until WTRVS’s light turning from green, red and to orange finally.