Parts List

ManualsBrandsClimax Technology ManualsElectronicsWater Leak Sensor

Water Leak Sensor (WLS-23)

Introduction

WLS-23 is a Water Leak Sensor. It is capable of sending wireless signals to the Control Panel upon water

detection. The Water Sensor can be placed on the ground, or mounted on the wall using the extension

cable to detect water leakage or flood condition. The Water Sensing Cable and built-in water sensing

probes can detect water leakage or flood condition. It can be placed on the ground, or mounted on the wall

and further extended by connecting to another water sensing cable to improve detection range.

Parts Identification

1. LED Indicator

- Continuous flash:

1) When the Water Sensor is transmitting a learning signal.

- Flashes twice:

1) When the Water Sensor receives acknowledgement from

the Control Panel.

- Flashes 3 times:

1) When the Learn/Test Button is pressed under normal

operation mode, and the device will emit 1 beep;

2) When the Learn/Test Button is pressed under low battery

status, and the device will emit 3 beeps;

3) When the Learn/Test button is pressed under normal

operation mode or while alarming.

- Flashes 10 times:

1) When battery power is provided to the device;

2) When the Water Sensor is transmitting an alarm signal,

and the device will beep continuously;

3) When the Water Sensor is transmitting a restore signal.

- Quick flashes every 4 seconds:

1) The battery is exhausted.

2. Buzzer

3. External Water Probe Connector

4. Battery Compartment

- The Water Leak Sensor is powered by one CR123 3V Lithium

battery.

5. Mounting Hook

6. Learn/Test Button (inside the cover)

- Press and hold the button for 3 seconds to transmit a learning

code.

- Press the “LEARN” button once to send a learning signal to the

Control Panel

- Press once to send a supervisory signal to the Control Panel

- Press once while alarming to enter Alarm Silence Mode.

7. Built-in water sensing probes

8. Waterproof Case

9. Battery Insulator

10. Learn (characters imprinted on the back cover)

Summary of content (5 pages)

PAGE 1
Water Leak Sensor (WLS-23) Introduction WLS-23 is a Water Leak Sensor. It is capable of sending wireless signals to the Control Panel upon water detection. The Water Sensor can be placed on the ground, or mounted on the wall using the extension cable to detect water leakage or flood condition. The Water Sensing Cable and built-in water sensing probes can detect water leakage or flood condition.
PAGE 2
Features  Water Detection  The Water Sensor will be activated when water is detected through: 1. The external water sensing cable. Please remove the pre-installed plastic plug from the external water probe connector, the Water Sensor will emit beep sound every 10 seconds for 5 minutes to indicate absence of plastic plug, please connect the external water probe to the connector (Refer to Mounting for details). 2. The built-in water sensing probe.
PAGE 3
 Water Sensing Cable A Water Sensing Cable or Water Probe Cable is available for selection. The cable can be further extended by connecting to another cable to improve detection range. Water Sensing Cable (earphone jack type) (used for WLS-23-S) Water Probe Cable (earphone jack type) User Guidelines  When water is detected through the Water Sensing Cable or Water Sensing Probe, the Water Sensor will start alarming and transmit an alarm signal to the Control Panel.
PAGE 4
 Avoid direct or indirect sunshine.  Improper storage can cause damage to the sensor and the cable.
PAGE 5
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.