Installation Instructions

3
activate a Help Alarm. When the button is pressed, VRA will emit one beep.
 The user can also speak the specific vocal command to activate a Help Alarm. When trigger word
“Help Me (English)” is repeated twice and recognized, VRA will emit one long beep.
 Please speak the trigger word “Help Me” twice within 5 seconds to trigger alarm.
 Pressing and holding the Button for 5 seconds or more will send a Cancel Code to the Control Panel
to stop the alarm.
Ways to Seek Help
OR
Speak the trigger Keyword twice
within 5 seconds.
<NOTE>

 To ensure voice recognition accuracy, please avoid installing VRA in a large or noisy room.

 The ideal environment for voice recognition is silence or partial silence. If you call out the vocal
command with normal voice, please speak within 2 meters of VRA to ensure alarm trigger.

 The voice recognition function has two sensitivity levels. You may test with them and select the level
that best suits your mounting location.
 Installation
After you conduct Walk Test to confirm VRA is within signal range of the Control Panel, and you are
satisfied that the selected sensitivity level works in the chosen location, you can proceed with installation.
There are two ways to install VRA: Wall Mounting and Surface Deployment.
 Wall Mounting
Ensure that VRA is fitted at approximately chest height (around 130cm-150cm above ground) where
the button can be easily accessed and operated.
1 Identify the keyhole on the back of VRA, drill one hole on the wall and fit the provided wall plug
(Figure 1). Fit the fixing screw and leave the non-threaded part for hanging VRA, as shown in
Figure 2.
Press and hold the Help Button for
more than 2 seconds.