Installation Instructions

ManualsBrandsClimax Technology ManualsElectronicsVoice Recognition Alarm

Voice Recognition Alarm (VRA)

The Voice Recognition Alarm (VRA) recognizes preset vocal commands or keywords and activates a Help

alarm. In addition to voice activation, the VRA also features a large button for users to summon help during an

emergency.



Parts Identification

Front View Back View Side View

1. Help Button (with Blue Backlight)

1. Press and hold for more than 2 seconds to send a learn

code or activate a panic alarm

2. Press and hold the button for 5 seconds to send a Cancel Code to the Control Panel.

3. Blue backlight will flash when signal is transmitted to the Control Panel.

2. LED Indicator (Green/Amber)

- Green LED ON: When external power supply is connected.

- Green LED OFF: When external power supply is removed.

- Amber LED flashes for three times: Low battery status detected when powerd on.

- Amber LED flashes once every 5 seconds: Low battery status detected during operation.

3. Microphone for VR (Voice Recognition)

4. Battery Compartment

5. DIP Switches

6. Keyhole

7. DC Jack (with Locking feature)

Plug in a DC 5V power adpator and rotate it 90 degrees clockwise to the lock position.

To remove the adaptror, rotate it 90 degrees counterclockwise to the original open

position and remove it.

 Power Supply



VRA can be powered by connecting to 5V DC power supply or two Type C batteries.



When VRA is connected to 5V DC power supply, green LED will turn on. When DC power supply is

removed, VRA will switch to using batteries (if batteries are already installed and not exhausted)

and continue operation; green LED will turn off.

Summary of content (5 pages)

PAGE 1
Voice Recognition Alarm (VRA) The Voice Recognition Alarm (VRA) recognizes preset vocal commands or keywords and activates a Help alarm. In addition to voice activation, the VRA also features a large button for users to summon help during an emergency.  Parts Identification Front View Back View Side View 1. Help Button (with Blue Backlight) 1. Press and hold for more than 2 seconds to send a learn code or activate a panic alarm 2.
PAGE 2
   When powered by Type C batteries, VRA will transmit any detected low battery status along with regular status signal transmissions to the Control Panel for display accordingly. When changing batteries, please remove the back cover by unscrewing the bottom fixing screw, and then inserting a flat-head screwdriver to lift the back cover. Remove the old batteries, and then press the Help Button twice to fully discharge before inserting new batteries.
PAGE 3
   activate a Help Alarm. When the button is pressed, VRA will emit one beep. The user can also speak the specific vocal command to activate a Help Alarm. When trigger word “Help Me (English)” is repeated twice and recognized, VRA will emit one long beep. Please speak the trigger word “Help Me” twice within 5 seconds to trigger alarm. Pressing and holding the Button for 5 seconds or more will send a Cancel Code to the Control Panel to stop the alarm.
PAGE 4
Figure 1 2 Figure 2 Fit the keyhole slot of VRA over the screw head. Gently and firmly push VRA downwards, as shown below. (Figure 5,6) Figure 5  Figure 6 Surface Placement VRA comes with an Anti-Slip pad on its back. The device can also be deployed on a flat surface without being installed at a fixed location.
PAGE 5
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.