User's Manual

 Joining the ZigBee Network
As a ZigBee device, the Status Display needs to join a ZigBee network to connect to the power device. Please follow
the steps bellow to join the Status Display into the ZigBee network.
1. Detach the Top Cover and Base assembly by loosening the Cover-Fixing Screw using a Philips screwdriver.
2. Press and hold the Function Button for 10 seconds for the Status Display to search and join an existing ZigBee
network. At the 10
th
second, the LED Display will flash red once. Please make sure to enable the permit-join
feature on the router or coordinator of your ZigBee network
3. If the Status Display successfully joins a ZigBee network, the LED Display will flash red twice to confirm.
4. After joining the ZigBee network, the Status Display will be registered in the network automatically. Please check
the ZigBee network coordinator, system control panel or CIE (Control and Indicating Equipment) to confirm if
joining and registration is successful.
5. If network joining and registration is unsuccessful, please check your ZigBee network coordinator, control panel or
CIE setting to ensure the permit-join function is available, and then use the Factory Reset function below to join the
ZigBee network.
 Removing Device from ZigBee Network (Factory Reset)
To remove the Status Display from current ZigBee network, the Status Display must be put to Factory Reset to
complete device removal. Factory Reset function will clear the device of its stored setting information and prompt the
Status Display to search for new ZigBee network.
Before removing device, make sure the Status Display is within current ZigBee network signal range
1. Press and hold the function button for 10 seconds, then release the button to reset Status Display.
2. Upon reset, the Status Display will clear current ZigBee network setting and transmit signal to ZigBee
coordinator to remove itself from current ZigBee network. It will then actively search for available ZigBee network
again and join the network automatically.
Installation
 Mounting the Status Display
The Status Display can be mounted using two methods: Self-adhesive or Screw mounting.
Self adhesive mounting
1. Clean the surface with a suitable degreaser.
2. Remove the protective covering from one side of double-sided adhesive pad and firmly apply to the back of the
device.
3. Remove the other covering and firmly place/press the device in the desired location.
Do not use the Self-adhesive mounting method on poorly painted and/or rough surfaces.
Screw Mounting
The base of the Status Display has two screw knockouts, where the plastic is
thinner for mounting purposes. To mount the Status Display:
1. Detach the Top Cover and Base assembly by loosening the Cover-Fixing
Screw using a Philips screwdriver.
2. Break through the knockouts on the base.
3. Use the holes as a template to drill two holes and insert the wall plugs.
4. Screw the base into the wall plugs.
5. Replace the top cover over the base by hooking the base onto the fixing
hook and pushing the cover towards the base.
6. Secure and screw the top cover back on to its base using a Philips
screwdriver.