User's Manual

z When the Queue Buffer is full, any signal received will be ignored.

z The data being transmitted will be put into another “Time-out Buffer” and a 10-sec

timer will start counting. If a signal received is already in the “Time-out Buffer”,

this signal will also be ignored.

z Changing the Dip Switch setting

z The RPN-99 reads the Dip Switch setting only during power-on. Therefore, be

sure to set the appropriate “Group Number”, “System ID” & “Unit ID” before power

it on.

z If it is necessary to charge the Dip Switch setting after power on, remember to

press the “Reset” button to do the power on Reset, otherwise the change will be

ignored.