User's Manual

5
RPN-99
z Front View of RPN-99:
LED 1: It is a dual-color LED, Green and
Red.
When the AC Power is ON, the
Green LED will stays on. If no
AC Power is connected and only
Battery is used for main power
source, then, the Green LED will
flash continuously.
If the Low Battery is detected,
the Red LED will stays on to warn the user for changing Power source.
LED 2: The Red LED will flash once when the RPN-99 receives a signal from other
RPN-99 or LT-49.
LED 3: The Red LED will flash once when the RPN-99 transmits its signal.
z Rear View (with Lid removed):
DC JACK: For connecting DC 12V 800 mA Power Adaptor.
SW1 : For setting the Group number,
please refer to the section
“BUN-152”. Make sure each unit
in a system should have the same
Group number.
SW2 : For setting the system ID code,
please refer to the section
“BUN-152”. Make sure each unit
in a system should have the same
system ID.
SW 3 : A 12-pin dip switch block to set the
“Unit ID Number”.
Each RPN-99 should be assigned an unique ID Number; so that the BUN-152 can
distinguish the signal received is from which RPN-99.
There are a total of 2
12
= 4096 combinations for a maximum of 4096 RPN-99’s to be
used in one system.