Parts List

3
Step 5: Upon receiving acknowledgement from the Control Panel, the three LEDs will flash three
times to indicate successful learning. The Relay Switch will then exit learning mode.
<NOTE>
 After entering learning mode, the Relay Switch will not automatically leave learning mode
unlesss it receives acknowledgement from the Control Panel, or unless the Test button is
pressed.
Walk Test
To test whether the Relay Switch is able to communicate with the Control Panel:
 Put the Control Panel into Walk Test mode.
 Press the Test Button on the Relay Switch.
 The Control Panel should display if the Relay Switch is within the operation range (please refer
to the operation manual of the Control Panel).
Mounting
 After you have finished the Walk Test, and you are satisfied that the device is able to
communicate with the Control Panel in the chosen location, proceed to mounting.
 Disconnect the main power supply.
 Loosen the bottom fixing screw and remove the top cover of the Relay Switch.
 Use the holes on the base to mark mounting location on the wall.
 Drill holes into marked location and insert wall plugs if required, screw the base onto the mounting
location.
 Replace the top cover and tighten the bottom fixing screw.
Operation
 After the Relay Switch is successfully learned in to the Control Panel, the Control Panel can
remotely control the Relay Channel 1/2/3 to turn On/Off. Please refer to your Control Panel for
details.
 The user can also manually press the Switch Button 1/2/3 to switch ON/OFF the Relay
Channel 1/2/3.
Supervision
 After the Relay Switch is successfully learned in to the Control Panel, the device will
automatically transmit Supervisory signals periodically to the Control Panel at random
intervals of 30 to 50 minutes.
 If the Control Panel has not received the signal from the Relay Switch for the preset period of
time, the Control Panel will indicate on its display that the particular Relay Switch is
experiencing an out-of-signal problem.
Factory Reset
 Factory resetting the Relay Switch will restore it to factory default settings.
 Press and hold the test button while powering on the Relay Switch, then release the button
when LEDs light up to factory reset.