Operation Manual

2
 After the Panic Button is learned successfully, press the Button to activate a Panic Alarm.
 Press and hold the Button for 8 seconds or more will send a Cancel Code to the Control Panel to
stop the alarm. (This function is not compatible with all control panels.)
 Mounting the Panic Button
The Panic Button can be mounted using two methods: Self-adhesive or Screw mounting.
 Self-adhesive mounting
I. Clean the surface with a suitable degreaser.
II. Remove the protective covering from one side of double-sided adhesive pad and firmly
apply to the back of the device.
III. Remove the other covering and firmly place/press the device in the desired location.
< NOTE >
 Do not use the Self-adhesive mounting method on poorly painted and/or rough
surfaces.
 Screw Mounting
The base has two screw knockouts, where the
plastic is thinner for mounting purposes. To mount
the Panic Button:
I. Remove the cover-fixing screw and
separate the top cover from the base.
II. Break through the knockouts on the base.
III. Use the holes as a template to drill two
holes and insert the wall plugs.
IV. Screw the base into the wall plugs.
V. Replace the top cover over the base by
hooking the base onto the fixing hook and
pushing the cover towards the base.
VI. Lightly tighten t