Operation Manual

1
Panic Button (PB-15)
The Panic Button is used to activate (or deactivate) a panic alarm.
 Parts
1. Panic Button / LED Indicator
Button usage:
1. Press to send a learn code or activate a
panic alarm.
2. Press and hold the button for 8 seconds to
send a Cancel Code to the Control Panel.
(This function is not compatiable with
every control panel)
LED Indicator:
1. The LED indicator will light up briefly
when the device is transmitting a signal.
2. The LED indicator will flash twice when
receivng acknowledgement from the
Control Panel.
2. Cover-Fixing Screw
3. Fixing Hook
4. Battery Compartment
 Battery
 The Panic Button is powered by one EL123AP Lithium battery.
 The Panic Button will transmit any detected low battery status along with any regular status signal
transmission to the Control Panel for display accordingly.
 When changing battery, after removing the old battery, press the button twice to fully discharge
before inserting new battery.
 Supervisory Signal
 The Panic Button will automatically transmit Supervisory Signals every 15 to 18 minutes.
 If the Control Panel has not received the signal from the Panic Button for a preset period of time,
the Control Panel will indicate that the Panic Button is out-of-signal range or is out of order.
 Getting Started
 Remove the cover-fixing screw using a Philips screwdriver and separate the cover from the base.
 Insert the battery according to the marked polarities.
 Replace the top over the base by hooking the base onto the fixing hook and pushing the cover
towards the base.
 Lightly tighten the screw.
 Put the Control Panel into learn mode.
 Press the button on the Panic Button to transmit a learn code.
 Refer to your Control Panel’s operation manual to complete the learn-in process.
 Walk Test
 Place the Control Panel in the walk test mode.
 Press the Button once.
 The Panel will display the RSSi (Radio Strength Signal) strength and sound a 2-tone beep.
 Operation