User's Manual

43
 158 – High Temperature
 When the temperature exceeds High Temperature setting.
 159 – Low Temperature
 When the temperature drops below Low Temperature setting.
 162 – CO detector
 301 – AC Failure
 When the AC power fails for more than 10 sec.
 302 – Low Battery
 When the Control Panel is under low battery.
 311 – Panel Battery Missing/Dead
 When the Control Panel Battery is missing or disconnected.
 344 – Interference
 374 – Arm with Fault
 When fault exists in system, and the system is armed by confirming the arm action.
(Arm Fault Type set to Confirm.)
 383 – Device Tamper
 When a device’s tamper switch is triggered.
 384 – Device Low Battery
 When a device’s is under low battery.
 389 – Self Test Failure
 400 – Arm/Disarm (by Remote Controller)
 When the system is armed or disarmed by using the Remote Controller.
 401 – Arm/Disarm by Panel
 When the system is armed or disarmed by entering the PIN code.
 408 – Set/Unset Disarm
 407 – Disarm/Away Arm/Home Arm by Remote Keypad
 456 – Home Arm
 465 – Alarm Reset
 570 – Zone Bypass
 When fault exists in system, and the system is armed by ignoring the fault event. (Arm
Fault Type set to Direct Arm)
 602 – Periodic test report
 When MZ-1/8 makes periodic Check-in reporting.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.