User's Manual

42
14. Event Code
The events are reported with a qualifier before the event code. The qualifier “1” means the event
has taken place, “3” means the event has been restored. For example, if the Control Panel
reports “1302”, it means the panel is under low battery; if the Control Panel reports “3302”. It
means the panel low battery condition has been restored.
 100 – Medical
 101 – Personal emergency
 When the Wrist Transmitter / Emergency Pendant (WTR) is pressed.
 102 – Inactive
 110 – Fire
 111 – Smoke
 When the Smoke Detector (SD) is triggered.
 114 – Heat
 When the Heat Detector (HD) is triggered.
 120 – Panic
 When the Panic Button of the Remote Controller (RC) is pressed.
 121 – Duress
 When the Duress Code is entered to disarm or arm the system.
 122 – Silent Panic
 When the panic button on a Remote Controller (RC) set to silent panic is pressed.
 130 – Burglar
 When any one of the following devices is triggered:
 The Door Contact (DC) set at Burglar (@ B)
 The Door Contact (DC) set at 24 Hours (@ H)
 The Door Contact (DC) set at Delay (@ D)
 The PIR set at Burglar (@ B)
 The PIR set at Delay (@ D)
 131 – Burglar Perimeter
 When a device set as Entry is triggered in away arm mode.
 132 – Burglar Interior
 When a device set at Entry is triggered in the home mode.
 137 – Panel Tamper
 When the Control Panel tamper switch is triggered.
 147 – Sensor Supervision Failure
 When MZ-1/8 fails to receive the signal transmitted from any one of the devices
individually for a preset period.
 151 – Gas
 154 – Water leakage
 When a Water Sensor or Door Contact set as Water is triggered.