User's Manual

37
9. Panel Control
Under this page, you can choose to Away Arm, Home Arm 1/2/3, or Disarm the system. If any
fault exists within the system, they will be displayed under this page.
 Current Mode
Control Panel current mode.
 Away Arm:
Away Arm will arm all devices in the system.
 Home Arm 1/2/3:
You can choose to arm the system in 3 different Home Arm mode.
 Under Home Arm 1, device set to Home Omit, Home 1/2 Omit or
Home 1/3 Omit will not raise an alarm when triggered.
 Under Home Arm 2, device set to Home Omit or Home 1/2 Omit will
not raise an alarm when triggered.
 Under Home Arm 3, device set to Home Omit or Home 1/3 Omit will
not raise an alarm when triggered.
 Fault Events
Fault events in system are listed in the Fault section. If you try to arm the system when
fault event exists a warning message “Fault Exists! Please Confirm!” will be displayed to
notify you. You will need to arm the system again to force arm the system. Alternatively,
you can select the fault events and click “Clear” to ignore the fault events. Cleared fault
event will no longer prevent you from arming the system.
If all fault events are cleared, the fault LED will no longer light up or flash.