User's Manual

29
 Name: Enter a name for the device, A maximum of 20 characters are allowed
 Zone: Select the device zone number.
 Attribute:
For Door Contact you are requested to select the device attribute from Burglar, Home
Omit, Home 1/2 Omit, Home 1/3 Omit, Home Access, Delay Zone, Away Only,
Entry, Away Entry, 24 Hr, Fire, Medical Emergency, Water, Set/Unset Silent Panic,
Personal Attack.
For PIR Sensor, you are requested to select the device attribute from Burglar, Home
Omit, Home 1/2 Omit, Home 1/3 Omit, Home Access, Delay Zone or Entry Zone.
For Remote Controller, you are requested to select the device attribute from Silent
Panick or Personal Attack.
Attribute List:
 Burglar
 When the system is in any Arm mode, if a “Burglar” device is triggered, a
“Burglar Alarm” will be activated immediately and reported.
 Home Omit
 When the system is in Home Arm 1/2/3 mode, if a “Home Omit” device is
triggered, the Control Panel will not raise alarm. It will still send a report for this
event
 When the system is in Full Arm mode, if a “Home Omit” device is triggered, the
Control Panel will respond in the same way as if a “Burglar” device is triggered.
 Home 1/2 Omit
 When the system is in Home Arm 1/2 mode, if a “Home 1/2 Omit” device is
triggered, the Control Panel will not respond. It will still send a report for this event
 When the system is in Away Arm or Home Arm 3 mode, if a “Home 1/2 Omit”
device is triggered, the Control Panel will respond in the same way as if a
“Burglar” device is triggered.
 Home 1/3 Omit
 When the system is in Home Arm 1/3 mode, if a “Home 1/3 Omit” device is
triggered, the Control Panel will not respond. It will still send a report for this event
 When the system is in Away Arm or Home Arm 2 mode, if a “Home 1/2 Omit”
device is triggered, the Control Panel will respond in the same way as if a
“Burglar” device is triggered.
 Home Access
 When the system is in Home mode, if a “Home Access” device is triggered, the
Control Panel will start an Entry Delay period to give enough time to disarm the
system. It will also send a report for this event
 When the system is in Full Arm mode, if a “Home Access” device is triggered,
the Control Panel will start a Burglar Alarm and a burglar message will be
reported.
 Delay Zone
 When the system is in any Arm mode, if a “Delay Zone” device is triggered, a
“Burglar Alarm” will be activated immediately and reported.