User's Manual

23
6. Device Management
This page for you to learn in, edit, delete and control all the accessory devices. A total of 40
devices are allowed to be learnt in to the system, including RF and ZigBee devices. Only 6 PIR
Cameras (VST-852/VST-852 Pro) or Video Camera (VST-873/VST-873Pro) can be learnt into
the system.
6.1. Learning
Step1. Under Disarm Mode, press “Start Learning”. The Control Panel will enter learning
webpage. The Control Panel LED 1 will flash green.
Step2. Press the learn button on your device, for ZigBee device, press and hold the learn button
for about 10 seconds (please refer to device manual for detail) to transmit a learn code.
Step3. If the Control Panel receives the learn code it will emit 2 short beeps, click the “Refresh”
button to display the device information on webpage. If the Control Panel emit 1 long
beep instead, it means the device has already been learned into the Control Panel.
<
<
N
N
O
O
T
T
E
E
>
>
 If the Control emits 2 short beep when learning in ZigBee sensors, but does not display