User's Manual

19
Factory default is set to 10 seconds.
 Exit Delay
Set the Exit Delay Timer for Away Arm, Home Arm 1, Home Arm 2, and Home Arm 3
modes. When you arm the system, the system will enter your selected arm mode after the
Exit Delay Timer expires
Factory default is set to 10 seconds.
 Alarm Length
When an alarm is activated, both the Control Panel siren and external siren will raise
alarm according to the Alarm Length setting.
Factory default is set to 3 minutes.
 Supervision Timer
Set the supervision timer for accessory devices, if no supervision signal is received within
set duration for a certain device, the Control Panel will report the situation accordingly.
Factory default is set to 12 hour.
 Sound Setting
 Door Chime: If not disabled, the Control Panel will sound a door chime sound when a
Door Contact set to Entry attribute is activated in Disarm mode. .
 Entry Arm: If not disabled, the Control Panel will sound beeping sounds when a Door
Contact set to Entry attribute is activated in Away Arm mode. .
 Entry Home: If not disabled, the Control Panel will sound beeping sounds when a Door
Contact set to Entry attribute is activated in Home Arm mode. .
 Exit Arm: If not disabled, the Control Panel will sound beeping sounds when during
Exit Delay Timer for Away Arm mode.
 Exit Home: If not disabled, the Control Panel will sound beeping sounds when during
Exit Delay Timer for Away Arm mode.
 Warning Beep: If not disabled, the Control Panel will sound beeping sounds every 30
seconds when fault exists within system.