User's Manual

18
5.4. Area
This page is for you to configure area settings.
 Final Door
 Final Door On: When the system is Away Armed with a Door Contact set to Entry
attribute, the system will automatically arm the system once the Door Contact is closed
even if the entry delay timer has not expired yet.
 Final Door Off: When the system is Away Armed with a Door Contact set to Entry
attribute, the system will only arm the system after the entry delay timer expires.
 Factory Default is set to Final Door Off.
 Arm Fault Type
 Confirm: When set to Confirm, If you attempt to arm when a fault exists within the
system, the arming action will be prohibited, and a message will be displayed “Fault
exists! Please Confirm!” You need to arm the system again to confirm your action and
arm the system. (Factory Default)
 Direct Arm: When set to Direct Arm, If you attempt to arm when a fault exists within
the system, the system will enter selected arm mode without further notification about
fault events.
 Factory Default is set to Confirm.
 Tamper Alarm
 Away Arm: Tamper alarm will only be activated when tamper switch is triggered under
Away Arm mode (Tamper event will still be reported normally in Home/Disarm mode).
 Always: Tamper alarm will be activated whenever tamper switch is triggered.
 Factory Default is set to Away Arm.
 Entry Delay
Set the Entry Delay Timer for Away Arm, Home Arm 1, Home Arm 2, and Home Arm 3
modes. When a device set to Entry attribute is triggered under arm mode, the Entry Delay
Timer will begin to countdown. The system must be disarmed before the timer expires or
an alarm will be activated.