User's Manual

5.3. Panel

This page is for you to configure panel settings.

 Keyword

The Keyword is used for receiving commands from users. When a user sends a command

to the Control Panel, the correct keyword must be entered along with a valid User PIN

code for the Control Panel to recognize the command. The Keyword is disabled by default.

(MZ-8 only)

 P-word

The P-word is also used for receiving commands from Installers. When an installer sends

a command to the Control Panel, the correct P-word must be entered along with Installer

code for the Control Panel to recognize the command. The P-word is “PROG” by default.

(MZ-8 only)

 AC Fail Report

This is for you to set the waiting time for the Control Panel to make report after detecting

AC failure. Factory default is set to 5 minutes.

 Jamming Report

This is for you to set whether the Control Panel should detect radio frequency interference

and make report when interference is detected. Factory default is set to On. When radio

jamming is detected, the Control Panel will report the event accordingly.

 Auto Check-in

This is for you to set the interval time the Control Panel waits before making a regular

check-in report