User's Manual
80
3
83 - IR Tamper Open
When an IR tamper is opened.
384 - All Devices Low on Battery
When all devices are low on battery, the green LED blinks every 2
seconds.
602 - Auto Check-In Report
When the Base Station makes an auto check-in report to the CMS.
606 - Follow-On Operation
When the Base Station receives a kiss-off from the
CMS to open the
speech channel.
641 - Inactivity
When the Base Station makes an inactivity timer expired report.
<
<
N
N
O
O
T
T
E
E
>
>
This event code will be sent with fixed zone number 072.
661 – Nurse or Help Has Arrived/Nurse’s Job Completed
When the green reset button on the Base Station is pressed to signal
that a nurse or help has arrived (1-661).
When the green reset button on the Base Station is pressed to signal
that the nurse’s job has been completed (3-661).
662 – Help Still Needed
When the red help button on the Base Station is pressed to signal that
help is still needed.
6
63 – Case Closed by the Nurse
When the green reset button on the Base Station is pressed twice
quickly to signal that the nurse closes the emergency case because
the user actually has no problem.
7.2. Scancom Event Codes
515555517 - Base Station Emergency/Pendant #1 Emergency/Fall
Emergency/WTR Emergency/PB Emergency (when two-way mode is
set for follow-on operation)
When the red help button on the Base Station is pressed.
When Pendant #1 is pressed or triggered.
When Fall Sensor is pressed or triggered.
When WTR (Pendant #1) or PB is pressed.
5
15555557 - Base Station Emergency/Pendant #1 Emergency/WS
Emergency/Fall Emergency/WTR Emergency/PB Emergency (when
two-way mode is not set for follow-on operation)