User's Manual

77
No Voice Prompt Condition
13 Inactivity timer expiring. Please reset. Played upon the expiry of the
inactivity timer and once
every 5 minutes afterwards
for 6 times (over a 30-minute
period). After the 30 minutes,
the Base Station will start
reporting (this warning period
is conditioned by the inactivity
warning timer and its default
is 30 minutes).
14 A fall has been detected. Played every 2-3 seconds
during the guard time of a fall
sensor
15 Fall detection has restored. Cancelling help call. Played after the reception of
a fall sensor’s cancel code
<
<
N
N
O
O
T
T
E
E
>
>
 When the green reset button is pressed, the Base Station will report all the
fault problems it is experiencing via voice prompts.
6.2.5. Walk Test (Range Test)
Set the Base Station in learning mode to test the operational ranges of
devices.
Step 1. Press and hold the yellow button for 6 seconds when the Base Station
is in idle mode.
Step 2. Release the yellow button after you hear double beeps. Afterwards a
short beep will be emitted to indicate the Base Station is now in
learning mode. The blue backlight begins to blink.
Step 3. Move the device to a desirable location in the house and press the test
button to observe the device’s operational range.
Step 4. If the Base Station responds with a long beep, it means the device is
within the operational range.
Step 5. Press the yellow button once to exit learning mode, or the Base Station
will exit learning mode automatically after 5 minutes of inactivity.
6.2.6. Factory Reset
The Base Station will clear all programmed parameter
s when the following
steps are taken.
Step 1. Unplug the power cord from the DC jack.
Step 2. Use a pen or screwdriver to slide the battery switch to the off position.