User's Manual

75
received successfully, the system will not go on to
dial the phone numbers
under the groups which have previously failed to receive the calls.
Retry Method
Retry cycle: Each phone number can be retried up to 3 times in one round.
During the retry period, the red backlight will be steady on.
 If one GPRS or SMS reporting fails during the retry cycle, the Base Station
will make a 10-second pause before starting another reporting. If any
reporting other than GPRS or SMS reporting fails during the retry cycle,
the Base Station will make a 1-minute pause before starting another
reporting. This cycle will repeat until one reporting has been answered
successfully.
 When one full round’s numbers (all numbers under Group 1 to Group 5)
have all failed, the Base Station will make a 5-minute pause before
starting another retry cycle.
6.2.3. Arming/Disarming the System
 The Base Station’s security functions are activated only when the Base
Station’s yellow button is programmed as a security button.
 When the Base Station’s yellow button is programmed as a security
button, you can arm/disarm your system following the procedures below:
- Arming the system: You can arm the system by using a Remote
Control (RC) or Keypad (KP) or by pressing the yellow button on the
Base Station. The Base Station will start the exit time countdown and
emit beeps during the countdown. During the last 10 seconds of the
exit time, the Base Station will emit two quick beeps every second to
urge you to leave the house as soon as possible. After the exit time
expires, the Base Station will emit a long beep to signal that the
system has entered armed mode.
<
<
N
N
O
O
T
T
E
E
>
>
 When you press the Base Station’s yellow button to arm the system and
the Base Station emits four beeps, the beeps signify the presence of
device fault(s). In this case the Base Station will not immediately start the
exit time countdown. If you want the Base Station to start the exit time
countdown immediately, please press the yellow button again and the
Base Station will enter exit time.
- Disarming the system: You can use a Remote Control (RC) or
Keypad (KP) to disarm the system. You can also disarm the system by
pressing the yellow button on the Base Station and then pressing a
Wrist Transmitter and Pendant Transmitter (WTR) button within 5