User's Manual

70
6.2.2. Alarm Activation
 When an alarm is triggered, the Base Station will enter guard time. Both
the orange backlight and the red help button’s backlight will turn steady on.
A voice prompt announcing “help call in progress” will be played every 2-3
seconds during guard time to alert the user.
 You can cancel the alarm reporting by pressing the reset button on the
Base Station during guard time. The Base Station will return to idle mode.
 You cannot cancel the alarm reporting by pressing the reset button on the
Base Station after guard time has expired.
<
<
N
N
O
O
T
T
E
E
>
>
 When the Mobile Unit is not inserted in the Base Station’s charging base,
the Base Station (MP-2 and MP-5) will not report to the phone numbers
with their “Type” set as “SMS_ID” or “SMS_TEXT” via PSTN. However, if
a trigger takes place on the Mobile Unit’s side, these phone numbers will
be reported to.
Confirmation Beeps
 After guard time expires, the Base Station will summon help based on the
programmed reporting methods. Beeps (about one beep per second) will
continue to be heard after the Base Station dials out to inform you that the
call is in progress (no matter which reporting method is adopted).
 Confirmation beeps stop after 2-3 minutes.
G
PRS Reporting Method
 Access Point Name, Username and Password need to be set via SMS
remote programming before GPRS reporting is activated.
 Access Point Name (APN): The name of an access point for GPRS.
Please ask your SIM card service provider for your APN.
 Username: Offered by your SIM card service provider. Please ask your
service provider for your GPRS username. If no username is required,
you may skip this step.
 Password: Offered by your SIM card service provider. Please ask your
service provider for your GPRS password. If no password is required,
you may skip this step.
<
<
N
N
O
O
T
T
E
E
>
>
 SMS remote programming is effective only when the Mobile Unit is
inserted on the Base Station.