User's Manual

68
 The interval between an AC power failure and the Base Station’s sending
the AC failure report (factory default is 5 minutes) is programmed as
explained in Step 10. System of 4.2. PC Programming Tool.
 After AC power has been restored for more than 5 minutes, the Base
Station will send an AC power restored report to the CMS.
 When the Base Station is experiencing an AC fault, it will not charge the
Mobile U nit. It will charge the Mobile Unit only after its AC power has been
restored.
6
.2.1.4. Base Station Low on Battery
 When a low battery condition has lasted 4-6 minutes, the Base Station will
report to the CMS and the green LED blinks every 2 seconds. The report
will be sent to all reporting numbers except for the phone numbers
programmed for speech reporting.
 After the battery voltage is restored and has lasted 5 minutes, the Base
Station will send a battery power restored report to the CMS and the green
LED will be steady on again.
6.2.1.5. Base Station’s Battery Disconnected
 The Base Station detects battery absence in the following situations:
- Battery switched off
- Battery not connected
- Battery failure
 When battery disconnection has lasted 30 minutes, the Base Station will
report to the CMS and the green LED blinks slowly.
 After the battery is restored and the restoration has lasted 30 minutes, the
Base Station will send a battery restored report to the CMS and the green
LED will be steady on again.
6.2.1.6. Devices Low on Battery
 When a device is low on battery, the Base Station’s green LED blinks
every 2 seconds (please refer to the figure on page 4 and the chart on
page 6).
 After the faulty battery is replaced, the Base Station will instantly send a
battery restored report to the CMS regarding the particular device.
 If multiple sensors are running low on battery, the green LED won’t stop
blinking until all the sensors’ low battery status has been cleared.