User's Manual

65
reset mode. All the Mobile Unit’s LEDs will be on fo
r 1 second and
then go off.
Step 2. Press the red button once within 10 minutes. After 3-5 seconds, all
LEDs will be on for 1 second and LED 2B (orange) will blink to
indicate the Mobile Unit’s GSM module has been reactivated.
<
<
N
N
O
O
T
T
E
E
>
>
 These steps will only reboot the Mobile Unit and will not remove any
programmed parameteres in the device.
2. Factory reset
The Mobile Unit will clear all programmed parameters when the following steps
are taken.
Step 1. Press the Mobile Unit’s red button for 15 seconds in any mode to enter
reset mode. All of the Mobile Unit’s LEDs will be on for 1 second and
go off.
Step 2. Give the red button 2 quick presses within 10 minutes to restore the
Mobile Unit to factory settings. The 2 quick presses must be
completed in 1 second. After 3-5 seconds, all the Mobile Unit’s LEDs
will be on for 1 second. Afterwards LED 2B (orange) will blink to
indicate a factory reset has been performed.
<
<
N
N
O
O
T
T
E
E
>
>
 All reporting settings in the Mobile Unit will be removed after a factory
reset. You will have to insert the Mobile Unit in the Base Station’s charging
base to program the settings again.
 When the Mobile Unit is inserted in the Base Station’s charging base to
get charged, its reporting settings will automatically be renewed.