User's Manual

61
progress. Confirmation beeps will last for 15-20 sec
onds.
 If two-way voice is selected, the Mobile Unit will not emit beeps but will
play this voice prompt: “Alarm received, please stand by” to remind the
user to prepare to answer the call.
GPRS Reporting Method
 Access Point Name, Username and Password need to be set via SMS
remote programming before GPRS reporting is activated.
 Access Point Name (APN): The name of an access point for GPRS.
Please ask your SIM card service provider for your APN.
 Username: Offered by your SIM card service provider. Please ask your
service provider for your GPRS username. If no username is required,
you may skip this step.
 Password: Offered by your SIM card service provider. Please ask your
service provider for your GPRS password. If no password is required,
you may skip this step.
<
<
N
N
O
O
T
T
E
E
>
>
 SMS remote programming is effective only when the Mobile Unit is
inserted on the Base Station.
Digital Reporting Method
Callback Operation
 After the alarm reporting has been successfully received by the CMS, the
Mobile Unit will follow your programmed choice to enter follow-on and/or
callback mode.
<
<
N
N
O
O
T
T
E
E
>
>
 If a trigger takes place on the Mobile Unit’s side, the Mobile Unit will enter
callback mode only after all groups have been reported to successfully.
The Mobile Unit’s LED 1A (green) will blink to indicate the dialing process
has been concluded.
 If your choice is callback or follow-on & callback after alarm reporting, the
Mobile Unit will wait 5 minutes for CMS personnel to call back after
reporting (available callback interval settings are 3
mins/5mins/10mins/15mins/20mins/30mins/1hr; factory default is 5
minutes).
 When the CMS calls back within the 5-minute period, the Mobile Unit will
auto answer the call after 2 beeps and wait for the proper entry of the
Access Code (default is 1111) followed by the (#) key in 15 seconds.
Please enter the Access Code at the normal operational speed.