User's Manual

is not pressed, the device will be automatically ass

igned to Zone 3~Zone

100 by sequence.

Step 7. Proceed to press the button of the next device until the Base Station

emits 2 beeps to indicate the device has been learned in. Please

repeat this procedure to learn in the rest of your devices. These

devices will be automatically assigned to Zone 3~Zone 100 by

sequence.

Step 8. After you have learned in all the devices, press the yellow button once

to exit learning mode (1 beep will be emitted), or the Base Station will

exit learning mode automatically after 5 minutes of inactivity. The blue

backlight will stop blinking upon the Base Station exiting learning

mode.

 Please refer to 6.2.3. Walk Test (Range Test) if you want to test the

operational ranges of your devices.

 You cannot learn in the same device twice. The Base Station will emit 1

long beep to remind you that the device has been learned in previously.

5.2. Removing Pendant #1, Pendant #2 and Other Devices

All devices (those assigned to Zone 3~Zone 100) can be removed via PC

programming but only Pendant #1 and Pendant #2 can be removed by the

local removing method. Please refer to Step 9. Sensors of 4.2. PC

Programming Tool for details of how to delete devices via PC programming.

Removing Pendant #1 and Pendant #2 via the local removing method:

Step 1. When the Base Station is in idle mode, press and hold the yellow

button for 3 seconds to enter learning mode.

Step 2. The Base Station will emit 1 beep once the yellow button is pressed.

Release the yellow button when you hear 2 beeps that indicate the

Base Station is now in learning mode. The blue backlight begins to

blink.

Step 3. Press the green reset button once to select Pendant #1. The Base

Station will emit 1 beep when the green reset button is pressed.

Step 4. Press the red help button of the Base Station for 3 seconds to delete

Pendant #1. The Base Station will emit 1 beep once the red help

button is pressed. Release the red help button when you hear 2

beeps that indicate Pendant #1 has been removed.

Step 5. Press the red help button once to select Pendant #2. The Base Station

will emit 1 beep when the red help button is pressed.

Step 6. Press the red help button of the Base Station for 3 seconds to delete