User's Manual

49
3. When the firmware update is completed, the messag
e
“STAT_SND_FW_END” will be shown at the bottom of the screen and the
Base Station will emit 2 beeps. Please carry out a manual factory reset (not
the factory reset via this PC Programming Tool) according to the following
steps after the completion of the firmware update.
Step 1. Unplug the power cord from the DC jack of the Base Station.
Step 2. Use a pen or screwdriver to slide the battery switch of the Base
Station to the off position.
Step 3. Plug the power cord into the DC jack while pressing both the help
button and the reset button of the Base Station until one long beep
is emitted to indicate the factory reset has been successfully
executed.
Step 4. Release both buttons.
Step 5. Slide the battery switch back to the on position.
<
<
N
N
O
O
T
T
E
E
>
>
 Once a factory reset is executed, all programmed data will return to
their default values and all learned-in devices will be removed. You will
have to do the programming and learn the devices in one by one
again.