User's Manual

38
2. Adding sensors:
 In addition to the local learning method, you can also use the “Add
Sensor” section on the “Sensors” page to learn sensors into the Base
Station.
 Enter the zone number (Zone 1~Zone 100) to which you wish to assign
a sensor and the Sensor ID, which is the barcode on the back of the
sensor, and click “Add Sensor.”
 If the sensor is successfully added, this sign will pop up
on the screen. An “OK” will be shown at the bottom left-hand corner of
the screen and the newly added sensor will appear on the sensor list.
 If you click “Add Sensor” and the word “Error” is shown at the bottom
left-hand corner of the screen, you may check whether the Sensor ID
is correct and whether the zone to which you assigned the sensor has
been occupied.