User's Manual

35
communication methods.
 The Access Code must be entered within 15 seconds, otherwise the
system will disconnect the call automatically.
 Press DTMF (9), the red help button on the Mobile Unit for five
seconds or the reset button on the Base Station to terminate the call.
 When callback time is up, the system will automatically exit the
waiting mode and return to idle mode.
 The callback function is automatically disabled during an AC power
failure period.
10. Two-Way Timer:
 After the system makes a report to the CMS, it will immediately enter
a two-way communication period as programmed by this setting.
This will enable the user to speak directly with the CMS personnel.
 Pressing an assigned DTMF key can extend the two-way
communication by another two-way period.
11. Supervision Timer Interval:
 This function is not available for Scancom and speech reporting.
 When this supervisory function is enabled, the Base Station will be
able to receive check-in signals from Wrist Pendants (WTR-),
Smoke Detector, Fall Sensor and Passive Infrared Motion Detector
that indicate the proper operation of the devices.
 When the supervision timer expires and no supervision signal is
received from WTR-, Smoke Detector, Fall Sensor or Passive
Infrared Motion Detector, a supervisory report will be made.
 The reporting method for a supervisory report is the same as that for
an emergency alarm. The report will be sent based on your reporting
method without guard time waiting.
12. Speaker Volume Two-Way:
 Select a preferred speaker volume level for two-way mode.
13. Speaker Volume Talk Only:
 Select a preferred speaker volume level for talk-only mode.
14. Speaker Volume Other:
 Select a preferred speaker volume level for other operations.
15. Sound Setting Guard Beep:
 Select “on” to enable beeps during guard time or “off” to disable the
beeping sound during guard time.